Product ID:CPS 291131, ASPHALT EMULSION CRS-2
MSDS Date:06/01/1987
FSC:9150
NIIN:00N030349
MSDS Number: BNNTW

CHEVRON

RICHMOND, CA 94804-0054
US

Emergency Phone: 800-457-2022

Info Phone: 801-524-7900

Cage: 0AHD1

CHEVRON ENVIRONMENTAL HEALTH CENTER INC

4054 RICHMOND, CA 94804 US

Telephone: 800-582-3835

Cage: 0AHD1

ASPHALT; (PETROLEUM ASPHALT)

CAS: 8052-42-4

RTECS: CI9900000

Fraction By Weight: 67%

ACGIH TLV: 5 MG/M3 FUME

WATER

CAS: 7732-18-5

RTECS: ZC0110000

NAPHTHA (PETROLEUM), LIGHT STRAIGHT-RUN; (LIGHT PETROLEUM

CAS: 64741-46-4

RTECS: QK8000300

Fraction By Weight: 2%

ALKYLAMINES; (ALKYLAMINE HYDROCHLORIDE)

Fraction By Weight: <1%

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES:EXPECTED TO CAUSE NO MORE THAN
MINOR IRRIT. SKIN:EXPECTED TO CAUSE NO MORE THAN MINOR IRRIT, BUT
PRLNG/ FREQUENTLY RPTD CONT MAY BE HARMFUL. INHAL/INGEST:NOT
EXPECTED TO BE ACUTELY TOX. IARC CONC LUDED THAT THERE WAS ONLY LTD
EVID THATSTEAM-REFINED ASPHALTS WERE CARCINOGENIC TO ANIMALS. MICE
EXPOS (EFTS OF OVEREXP
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:TO ASPHALTS DILUTED W/HYDROCARBON
SOLVS HAD INCR INCIDENCE OF CERTAIN TYPES OF CANCER. PETRO SOLV
CONTAINED IN PROD MAY INCREASE POTNTL FOR CANCER FOLLOWING PRLNG &
RPTD SKIN CONT. WHILE NORM HNDLG OF PROD IS NOT LIKELY TO CAUSE
CANCER IN HUMANS, SKIN CONT & BRTHG OF MISTS, FUMES/VAPS SHLD BE
REDUCED TO MIN.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:EYES:FLUSH IMMED W/FRESH H2O FOR @ LST 15 MINS WHILE HOLDING
EYELIDS OPEN. IF IRRIT PERSISTS, SEE MD. SKIN:REMOVE HEAVILY CONTAM
CLTHG & WASH THORO W/SOAP & H2O. DO NOT USE SOLVS/THINNERS TO
REMOVE MA TLS FROM SKIN. ASPHALT CAN BE REMOVED W/VEGETABLE
OIL/MINERAL OIL. INHAL:REMOVE TO FRESH AIR. SUPPORT BRTHG (GIVE
O2/ARTF RESP) . INGEST:GIVE H2O/MILK TO DRINK & CALL FOR MED
ADVICE.(SUPDAT)

Extinguishing Media:CO2, DRY CHEMICAL, FOAM, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT . SEE HAZARDOUS DECOMPOSITION PRODUCTS. READ
ENTIRE MSDS.
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.

Spill Release Procedures:CLEAN UP SM SPILLS USING APPROP TECHNIQUES
SUCH AS SORBENT MATLS/PUMPING. WHERE FEASIBLE & APPROP, REMOVE
CONTAM SOIL. FOLLOW PRESCRIBED PROCS FOR REPORTING & RESPONDING TO
LGR RELEASES. MATL MAY BE T OX TO AQUATIC ORGANISMS & SHLD BE KEPT
OUT(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:READ & OBSERVE ALL PRECS ON PROD LBL.
DO NOT WELD, HEAT/DRILL CNTNR. REPLACE CAP/BUNG. CAUTION! DO NOT
USE PRESS TO EMPTY DRUM/EXPLO MAY RESULT.
Other Precautions:EMPTIED CNTNR STILL CONTAINS HAZ MATL WHICH MAY
IGNITE W/EXPLO VIOLENCE IF HEATED SUFFICIENTLY. HYDROCARB SOLV IN
PROD MAY ACCUM AT EXPLO LEVELS IN HEADSPACE OF STOR CNTNRS. DO NOT
GET IN EYES. AVOID PRLNG/FREQUENTLY RPTD SKIN CONT (SUPDAT)

Respiratory Protection:WEAR NIOSH/MSHA APPROVED RESPIRATORY PROTECTION
SUCH AS AN ORGANIC VAPOR CARTRIDGE RESPIRATOR OR AN AIR-SUPPLYING
RESPIRATOR UNLESS VENTILATION IS ADEQUATE.
Ventilation:USE THIS MATERIAL ONLY IN WELL VENTILATED AREAS.
Protective Gloves:IMPERVIOUS PROTECTIVE GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:SKIN CONTACT CAN BE MINIMIZED BY WEARING
IMPERVIOUS PROTECTIVE CLOTHING.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
FIRST AID PROC:CALL MD BEFORE INDUCING VOMITING. IF MED ADVICE CANNOT
BE OBTAINED, THEN TAKE PERSON & PROD CNTNR TO NEAREST MED EMER
TREATMENT CENTER OR HOSPITAL. SPILL PROC:OF SEWAGE & DRAINAGE SYSTE
MS & ALL BODIES OF WATER. OTHER PREC:W/MATL. KEEP OUT OF REACH OF
CHILDREN.

HCC:C3
Boiling Pt:B.P. Text:212F,100C
Melt/Freeze Pt:M.P/F.P Text:30.0F,-1.1C
Vapor Pres:60 @ 100F
Spec Gravity:1.01 @ 15.6C
pH:3-7
Solubility in Water:READILY DISPERSIBLE
Appearance and Odor:TAN TO DARK LIQUID.
Percent Volatiles by Volume:32

Stability Indicator/Materials to Avoid:YES
MAY REACT W/STRONG OXIDIZING MATERIALS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NORMAL COMBUST FORMS CO2 & WATER VAPOR
& MAY PRDCE SOX; INCOMPLETE COMBUST CAN PRDCE CO.

Waste Disposal Methods:PLACE CONTAM MATLS IN DISP CNTNRS & DISPOSE OF
IN A MANNER CONSISTENT W/APPLIC REGS. CONTACT LOCAL ENVIRON/HLTH
AUTHS FOR APPRVD DISP OF MATL. DISP MUST BE I/A/W FEDERAL, STATE &
LOCAL REGULATIONS (FP N).

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.